Here you will find the manual for our Digital LED strips (Product No. 704.80 and 704.81).
The Digital LED strips offer 164 controllable functions for a wide range of light effects. The controller allows you to mix colours in dynamic patterns. Switching and dimming is easy using the remote control. Starting from the end of the strip, you can switch off individual segments of nine LEDs each. That means you can position the strip in the right length wherever you want it.
On/Off
Selection of pre-set white tones
When selecting a single colour with the "CS" button, the arrow buttons allow an incremental dimming (up for brighter, down for darker).
CS = Colour Selection: Select one of 8 pre-set colours by pressing the button repeatedly. Once you have selected a colour, you can then apply light effects.
C3 = 3 Colours: A block of three colours is selected. Once you have selected a preset block, you can then apply other light effects.
C7 = 7 Colours: A block of seven colours is selected. Once you have selected a preset block, you can then apply other light effects.
C16 = 16 Colours: A block of 16 colours is selected. Once you have selected a preset block, you can then apply other light effects.
Selecting the "IC Set" button electronically truncates the strip. The strip length is deactivated segment by segment by pressing the down arrow. All light settings will then only be applied to the remaining active strip segments. This function may come in useful when the strip was routed and an overlapping end is no longer visible. The advantage over trimming the end with scissors is that the full length of the strip can be reactivated if it is moved elsewhere. Select "IC Set" and press the up arrow until the lighting effects are once again applied to all segments once again.
“IC Set” activates/deactivates the electronic truncating function. The arrow buttons activate (arrow up) or deactivate (arrow down) the strip segments one by one.
When a function button is pressed, then the arrow buttons set the speed of the lighting effect (up for faster, down for slower).
Light effect “Auto”: You can choose for a light effect to run from both strip ends towards the middle or from the middle outward. The speed of the effect is set via the arrow buttons.
Light effect “Trail”: A preselected sequence of colours runs from left to right or right to left along the strip. The speed of the effect is set via the arrow buttons.
Light effect “Flash”: A preselected sequence of colours lights up in blocks from left to right or right to left. The speed of the effect is set via the arrow buttons.
Light effect “Jump”: A preselected sequence of colours lights up along the length of the strip, with one colour following the next; the sequence can run from right to left or left to right. The speed of the effect is set via the arrow buttons.
Light effect “Meteor”: A colour builds in the front of the strip and then runs the entire length of the strip; depending on the colour sequence selected, the next colour will build at the front of the strip; the sequence can run from right to left or left to right. The speed of the effect is set via the arrow buttons.
Function button “Auto”: A preselected colour sequence runs through all available light effects one by one. The speed of the effect is set via the arrow buttons.
Function button “Trail”: The "Trail" light effect runs through all preselected colours continuously, alternating between running left to right and right to left. The speed of the effect is set via the arrow buttons.
Function button “Flash”: A preselected colour sequence is displayed along the entire length of the strip. The speed of the effect is set via the arrow buttons.
Function button “Jump”: A preselected colour sequence lights up along the entire length of the strip. The speed of the effect is set via the arrow buttons.
Function button “Meteor”: The light effect “Queued” runs the selected colour sequence alternating from left to right and right to left. The speed of the effect is set via the arrow buttons.
